When buying a digital caliper, I recommend getting one capable of double-digit measurement. You can get one from Amazon, Aliexpress or Banggood. When performing the Flow Rate Calibration, you need to have a caliper for measuring the wall thickness of the printed part. Sometimes, printers come with a good-enough E-step value, but in order to get accurate prints it’s recommended to double check this. I covered the extruder calibration process in this article. In order to do an accurate flow rate calibration, the Extruder E steps need to be calibrated first. If the extruder steps are properly calibrated, the flow rate value should be really close to a single digit value (1.00). Besides this, flow rate calibration can also improve retraction values a bit and help with bulging corners and layer seam. Also known as Extrusion Multiplier, by calibrating the flow rate you can fix issues caused by under-extrusion or over-extrusion. The flow rate calibration is done in order to fine tune the amount of plastic extruded by the printer. 4 Wrapping Up Why do the Flow Rate Calibration?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |